Speaker Meira Kumar has urged political parties to arrive at a consensus on the women’s reservation bill. The 2008 Bill has the following main features. 1. It reserves one-third of all seats in Lok Sabha and Legislative Assemblies within each state for women. 2. There is quota-within-quota for SCs, STs and Anglo-Indians. 3. The reserved seats will be rotated after each general elections – thus after a cycle of three elections, all constituencies would have been reserved once. This reservation will be operational for 15 years. This Bill has had a chequered history. A similar Bill was introduced in 1996, 1998 and 1999 – all of which lapsed after the dissolution of the respective Lok Sabhas. A Joint Parliamentary Committee chaired by Geeta Mukherjee examined the 1996 Bill and made seven recommendations. Five of these have been included in the latest 2008 Bill. These are (i) reservation for a period of 15 years; (ii) including sub-reservation for Anglo Indians; (iii) including reservation in cases where the state has less than three seats in Lok Sabha (or less than three seats for SCs/STs); (iv) including reservation for the Delhi assembly; and (v) changing “not less than one-third” to “as nearly as may be, one-third”. Two of the recommendations are not incorporated in the 2008 Bill. The first is for reserving seats in Rajya Sabha and Legislative Councils. The second is for sub-reservation for OBC women after the Constitution extends reservation to OBCs. The 2008 Bill was referred to the Standing Committee on Law and Justice. This Committee failed to reach a consensus in its final report. The Committee has recommendedthat the Bill “be passed in Parliament and put in action without further delay. Two members of the Committee, Virender Bhatia and Shailendra Kumar (both belonging to the Samajwadi Party) dissented stating that they were not against providing reservation to women but disagreed with the way this Bill was drafted. They had three recommendations: (i) every political party must distribute 20% of its tickets to women; (ii) even in the current form, reservation should not exceed 20% of seats; and (iii) there should be a quota for women belonging to OBCs and minorities. The Standing committee considered two other methods of increasing representation. One suggestion (part of election commission recommendations) was to requite political parties to nominate women for a minimum percentage of seats. The committee felt that parties could bypass the spirit of the law by nominating women to losing seats. The second recommendation was to create dual member constituencies, with women filling one of the two seats from those constituencies. The Committee believed that this move could “result in women being reduced to a subservient status, which will defeat the very purpose of the Bill”. It is interesting to note that the Committee did not reject the two recommendations of the Geeta Mukherjee Committee that are not reflected in the Bill. The Committee concluded that the issue of reservations to Rajya Sabha and Legislative Councils needs to be examined thoroughly as the upper Houses play an equally important role under the Constitution. Incidentally, it is not possible to reserve seats in Rajya Sabha given the current system of elections to that house (see Appendix below). On the issue of reservations to OBC women, the Committee said that “all other issues may be considered at an appropriate time by Government without any further delay at the present time in the passage of the Bill”. Though the Bill does not have a consensus – it has been opposed by SP, RJD and JD(U) – most parties have publicly expressed their support for it. The government will likely not find it difficult to muster two-third support in each House of Parliament were the Bill be taken up for consideration and passing. It would be interesting to see whether the Bill is brought before Parliament in the upcoming Budget Session. Appendix: Impossibility of Reservation in Rajya Sabha Article 80of the Constitution specifies that members of state assemblies will elect Rajya Sabha MPs through single transferable vote. This implies that the votes are first allocated to the most preferred candidate, and then to the next preferred candidate, and so on. This system cannot accommodate the principle of reserving a certain number of seats for a particular group. Currently, Rajya Sabha does not have reservation for SCs and STs. Therefore, any system that provides reservation in Rajya Sabha implies that the Constitution must be amended to jettison the Single Transferable Vote system.
Recently, the Supreme Court collegium reiterated its recommendations for the appointment of 11 judges to certain High Courts. It had first recommended these names earlier this year and in August last year, but these appointments were not made. The Indian judiciary faces high vacancies across all levels (the Supreme Court, High Courts, and subordinate courts). Vacancy of judges in courts is one of the reasons for delays and a rising number of pending cases, as there are not enough judges to hear and decide cases. As of today, more than four crore cases are pending across all courts in India. In this blog post, we discuss vacancies across courts over the years, delays in appointment of judges, and methods to determine the adequate judge strength required to handle the caseload courts face.
High vacancy of judges across courts
Vacancies in courts keep on arising periodically due to retirement, resignation, demise, or elevation of judges. Over the years, the sanctioned strength of judges in both High Courts and subordinate courts has been increased gradually. However, vacancies persist due to insufficient appointments (see Figures 1 and 2). Between 2010 and 2020, vacancies increased from 18% to 21% across all levels of courts (from 6% to 12% in the Supreme Court, from 33% to 38% in High Courts, and from 18% to 20% in subordinate courts).
|
Figure 1: Vacancy of judges in High Courts |
Figure 2: Vacancy of judges in subordinate courts |
|
|
|
|
Sources: Court News 2010-2018; Vacancy Statement, and Rajya Sabha replies, Part I, Budget Session (2021), Department of Justice; PRS. |
|
As on November 1, 2021, the Supreme Court had a vacancy of one judge (out of a sanctioned strength of 34). Vacancy in High Courts stood at 37% (406 posts vacant out of a sanctioned strength of 1,098). Since May, 2021, the Supreme Court collegium has recommended more than 130 names for appointment as High Court judges. In three High Courts (Telangana, Patna, and Calcutta), at least half of the posts are vacant (see Figure 3). The Standing Committee on Personnel, Public Grievances, Law and Justice (2020) noted that every year, 35-40% of posts of High Court judges remain unfilled.
|
Figure 3: Vacancy of judges across High Courts (in %) (as on November 1, 2021)
|
|
Source: Vacancy Statement, Department of Justice; PRS. |
Appointments of High Court judges are guided by a memorandum of procedure. As per this memorandum, the appointment process is to be initiated by the concerned High Court at least six months before a vacancy occurs. However, the Standing Committee (2021) noted that this timeline is rarely adhered to by High Courts. Further, in the final stage of the process, after receiving recommendations from the Supreme Court collegium, the executive appoints judges to the High Court. No timeline is prescribed for this stage of the appointment process. In 2018 and 2019, the average time taken to appoint High Court judges after receiving the collegium’s recommendations was five to seven months.
As of today, over 3.6 crore cases are pending before subordinate courts in India. As on February 20, 2020, 21% posts for judges were vacant (5,146 posts out of the sanctioned strength of 24,018) in subordinate courts. Subordinate courts in Bihar, Haryana, and Jharkhand (among the states with high population) had a high proportion of vacancies of judges (see Figure 4). Note that the Supreme Court is monitoring the procedure for appointment of judges to subordinate courts.
For an analysis of the data on pendency and vacancies in the Indian judiciary, see here.
Figure 4: Vacancy of judges across subordinate courts (in %) (as on February 20, 2020)
|
|
|
Source: Report No. 101, Standing Committee on Personnel, Public Grievances, Law and Justice (2020); PRS. |
How many judges do we need?
The Law Commission of India (1987) had noted the importance of manpower planning for the judiciary. Lack of adequate number of judges means a greater workload per judge. Thus, it becomes essential to arrive at an optimal judge strength to deal with pending and new cases in courts. Over the years, different methods of calculating the required judge strength for subordinate courts (where the backlog of cases in the Indian judiciary is concentrated) have been recommended (see Table 1).
Table 1: Methods recommended for calculating the required number of judges for subordinate courts
|
Method of calculation |
Recommendation and its status |
|
Judge-to-population ratio: optimum number of judges per million population |
The Law Commission of India (1987) had recommended increasing this ratio to 50 judges per million people. This was reiterated by the Supreme Court (2001) and the Standing Committee on Home Affairs (2002). For 2020, the judge-to-population ratio was 21 judges per million population. Note that this figure is calculated based on the sanctioned strength of judges in the Supreme Court, High Courts and subordinate courts. |
|
Rate of disposal: number of additional judges required (to clear the existing backlog of cases and ensure that new backlog is not created) based on the average number of cases disposed per judge |
The Law Commission of India (2014) proposed this method. It rejected the judge-to-population ratio method, observing that filing of cases per capita varies substantially across geographic units depending on socio-economic conditions. |
|
Weighted case load method: calculating judge strength based on the disposal by judges, taking into account the nature and complexity of cases in local conditions |
The National Court Management Systems Committee (NCMS) (2016) critiqued the rate of disposal method. It proposed, as an interim measure, the weighted case load method, which addresses the existing backlog of cases as well as the new flow of cases every year in subordinate courts. In 2017, the Supreme Court accepted this model. |
|
Time-based weighted case load method: calculating the required judge strength taking into account the actual time spent by judges in different types of cases at varying stages based on an empirical study |
Used widely in the United States, this was the long-term method recommended by the NCMS (2016) to assess the required judge strength for subordinate courts. It involves determining the total number of ‘judicial hours’ required for disposing of the case load of each court. The Delhi High Court used this approach in a pilot project (January 2017- December 2018) to calculate the ideal judge strength for disposing of pending cases in certain courts in Delhi. |
Sources: Reports No. 120 (1987) and 245 (2014), Law Commission of India; Report No. 85, Standing Committee on Home Affairs (2002); Note for Calculating Required Judge Strength for Subordinate Courts, National Court Management Systems Committee (NCMS) (2016); Imtiyaz Ahmad vs. State of Uttar Pradesh, Supreme Court (2017); PRS.
