Applications for LAMP Fellowship 2025-26 are now open. Apply here. The last date for submitting applications is December 21, 2024
The Supreme Court passed its judgment in General Officer Commanding (Army) vs. CBI on May 01, 2012. The case addressed the issue of need for sanction to prosecute Army officers under the Armed Forces Special Powers Act (AFSPA). The case dealt with two instances of alleged fake encounters. Five people were killed by the Army in Assam in a counter insurgency operation in 1994. Another five people were killed in Jammu and Kashmir in March, 2000 in an encounter. In both cases, it was alleged that the Army officers had staged fake encounters. In both instances, the CBI was directed to investigate the matter. CBI claimed that the people who were killed were indeed victims of fake encounters. The CBI moved the court to initiate prosecution against the accused Army officers. The officers claimed that they could only be prosecuted with the prior sanction (permission) of the central government. The officers relied on provisions of the AFSPA,1958 and the Armed Forces J & K (Special Powers) Act, 1990 to support their claim. (See Notes for the relevant clauses) These provide that legal proceedings cannot be instituted against an officer unless sanction is granted by the central government. It must be noted that Army officers can be tried either before criminal courts or through court-martial (as prescribed under Sections 125 of the Army Act, 1950). The Army officers had appealed that both procedures require prior sanction of the government. The judgment touches upon various issues. Some of these have been discussed in more detail below:
Is prior sanction required to prosecute army officers for 'any' act committed in the line of duty? The judgment reiterated an earlier ruling. It held that sanction would not be required in 'all' cases to prosecute an official. The officer only enjoys immunity from prosecution in cases when he has ‘acted in exercise of powers conferred under the Act’. There should be 'reasonable nexus' between the action and the duties of the official. The Court cited the following example to highlight this point: If in a raid, an officer is attacked and he retaliates, his actions can be linked to a 'lawful discharge of duty'. Even if there were some miscalculations in the retaliation, his actions cannot be labeled to have some personal motive. The Court held that the AFSPA, or the Armed Forces (J&K) Special Powers Act, empowers the central government to ascertain if an action is 'reasonably connected with the discharge of official duty' and is not a misuse of authority. The courts have no jurisdiction in the matter. In making a decision, the government must make an objective assessment of the exigencies leading to the officer’s actions. At what stage is sanction required? The Court ruled that under the AFSPA, or the Armed Forces (J&K) Special Powers Act, sanction is mandatory. But, the need to seek sanction would only arise at the time of cognizance of the offence. Cognizance is the stage when the prosecution begins. Sanction is therefore not required during investigation. Is sanction required for court-martial? The Court ruled that there is no requirement of sanction under the Army Act, 1950. Hence, if the Army chooses, it can prosecute the accused through court-martial instead of going through the criminal court. The Court noted that the case had been delayed for over a decade and prescribed a time bound course of action. It asked the Army to decide on either of the two options - court martial or criminal court - within the next eight weeks. If the Army decides on proceedings before the criminal court, the government will have three months to determine to grant or withhold sanction. Notes Section 6 of the AFSPA, 1958: "6. Protection to persons acting under Act – No prosecution, suit or other legal proceeding shall be instituted, except with the previous sanction of the Central Government, against any person in respect of anything done or purported to be done in exercise of the powers conferred by this Act." Section 7 of the Armed Forces (J&K) Special Powers Act, 1990: "7. Protection of persons acting in good faith under this Act. No prosecution, suit or other legal proceeding shall be instituted, except with the previous sanction of the Central Government, against any person in respect of anything done or purported to be done in exercise of the powers conferred by this Act."
Recently, the Supreme Court collegium reiterated its recommendations for the appointment of 11 judges to certain High Courts. It had first recommended these names earlier this year and in August last year, but these appointments were not made. The Indian judiciary faces high vacancies across all levels (the Supreme Court, High Courts, and subordinate courts). Vacancy of judges in courts is one of the reasons for delays and a rising number of pending cases, as there are not enough judges to hear and decide cases. As of today, more than four crore cases are pending across all courts in India. In this blog post, we discuss vacancies across courts over the years, delays in appointment of judges, and methods to determine the adequate judge strength required to handle the caseload courts face.
High vacancy of judges across courts
Vacancies in courts keep on arising periodically due to retirement, resignation, demise, or elevation of judges. Over the years, the sanctioned strength of judges in both High Courts and subordinate courts has been increased gradually. However, vacancies persist due to insufficient appointments (see Figures 1 and 2). Between 2010 and 2020, vacancies increased from 18% to 21% across all levels of courts (from 6% to 12% in the Supreme Court, from 33% to 38% in High Courts, and from 18% to 20% in subordinate courts).
|
Figure 1: Vacancy of judges in High Courts |
Figure 2: Vacancy of judges in subordinate courts |
|
|
|
|
Sources: Court News 2010-2018; Vacancy Statement, and Rajya Sabha replies, Part I, Budget Session (2021), Department of Justice; PRS. |
|
As on November 1, 2021, the Supreme Court had a vacancy of one judge (out of a sanctioned strength of 34). Vacancy in High Courts stood at 37% (406 posts vacant out of a sanctioned strength of 1,098). Since May, 2021, the Supreme Court collegium has recommended more than 130 names for appointment as High Court judges. In three High Courts (Telangana, Patna, and Calcutta), at least half of the posts are vacant (see Figure 3). The Standing Committee on Personnel, Public Grievances, Law and Justice (2020) noted that every year, 35-40% of posts of High Court judges remain unfilled.
|
Figure 3: Vacancy of judges across High Courts (in %) (as on November 1, 2021)
|
|
Source: Vacancy Statement, Department of Justice; PRS. |
Appointments of High Court judges are guided by a memorandum of procedure. As per this memorandum, the appointment process is to be initiated by the concerned High Court at least six months before a vacancy occurs. However, the Standing Committee (2021) noted that this timeline is rarely adhered to by High Courts. Further, in the final stage of the process, after receiving recommendations from the Supreme Court collegium, the executive appoints judges to the High Court. No timeline is prescribed for this stage of the appointment process. In 2018 and 2019, the average time taken to appoint High Court judges after receiving the collegium’s recommendations was five to seven months.
As of today, over 3.6 crore cases are pending before subordinate courts in India. As on February 20, 2020, 21% posts for judges were vacant (5,146 posts out of the sanctioned strength of 24,018) in subordinate courts. Subordinate courts in Bihar, Haryana, and Jharkhand (among the states with high population) had a high proportion of vacancies of judges (see Figure 4). Note that the Supreme Court is monitoring the procedure for appointment of judges to subordinate courts.
For an analysis of the data on pendency and vacancies in the Indian judiciary, see here.
Figure 4: Vacancy of judges across subordinate courts (in %) (as on February 20, 2020)
|
|
|
Source: Report No. 101, Standing Committee on Personnel, Public Grievances, Law and Justice (2020); PRS. |
How many judges do we need?
The Law Commission of India (1987) had noted the importance of manpower planning for the judiciary. Lack of adequate number of judges means a greater workload per judge. Thus, it becomes essential to arrive at an optimal judge strength to deal with pending and new cases in courts. Over the years, different methods of calculating the required judge strength for subordinate courts (where the backlog of cases in the Indian judiciary is concentrated) have been recommended (see Table 1).
Table 1: Methods recommended for calculating the required number of judges for subordinate courts
|
Method of calculation |
Recommendation and its status |
|
Judge-to-population ratio: optimum number of judges per million population |
The Law Commission of India (1987) had recommended increasing this ratio to 50 judges per million people. This was reiterated by the Supreme Court (2001) and the Standing Committee on Home Affairs (2002). For 2020, the judge-to-population ratio was 21 judges per million population. Note that this figure is calculated based on the sanctioned strength of judges in the Supreme Court, High Courts and subordinate courts. |
|
Rate of disposal: number of additional judges required (to clear the existing backlog of cases and ensure that new backlog is not created) based on the average number of cases disposed per judge |
The Law Commission of India (2014) proposed this method. It rejected the judge-to-population ratio method, observing that filing of cases per capita varies substantially across geographic units depending on socio-economic conditions. |
|
Weighted case load method: calculating judge strength based on the disposal by judges, taking into account the nature and complexity of cases in local conditions |
The National Court Management Systems Committee (NCMS) (2016) critiqued the rate of disposal method. It proposed, as an interim measure, the weighted case load method, which addresses the existing backlog of cases as well as the new flow of cases every year in subordinate courts. In 2017, the Supreme Court accepted this model. |
|
Time-based weighted case load method: calculating the required judge strength taking into account the actual time spent by judges in different types of cases at varying stages based on an empirical study |
Used widely in the United States, this was the long-term method recommended by the NCMS (2016) to assess the required judge strength for subordinate courts. It involves determining the total number of ‘judicial hours’ required for disposing of the case load of each court. The Delhi High Court used this approach in a pilot project (January 2017- December 2018) to calculate the ideal judge strength for disposing of pending cases in certain courts in Delhi. |
Sources: Reports No. 120 (1987) and 245 (2014), Law Commission of India; Report No. 85, Standing Committee on Home Affairs (2002); Note for Calculating Required Judge Strength for Subordinate Courts, National Court Management Systems Committee (NCMS) (2016); Imtiyaz Ahmad vs. State of Uttar Pradesh, Supreme Court (2017); PRS.
